Yes, double the speed or more of other leading brands. Here is an example for T30 r3 tooling.
The first tool in the setis the Razorstone (a pre-cutting tool) with a feedrate of 2000 to 6000 mm/min (80 to 236 inch/min). The following 3 diamonds feedrate is 6000 to 7500 mm/min
(236 to 295 inch/min. )
Less than half the setup time
These tools are Z calibtrated from the factory. This means the whole set has the same Z height.
Measure the Z height of position 3 and enter that measure for all seven tools in the set.
When it comes time to replace these tools, the only thing you need to enter is the new diameter which is indicated on the new tool. The height remains the same.
Never need to redress the diamonds
Some other brands need to be sent to the manufacturer for redressing after several months use.
This is not only an extra cost but causes a hugh inconvenience and having to spend time finding
the new Z height.
Superior finish
Customers constantly remark on how the finish is far superior with Marmoelettromeccanica tools, smoother finish with no lines resulting in a product that is showroom ready.
HomeAboutGalleryProductsContactStoneGlassTooling
Home
